diff --git a/README.md b/README.md index fd063b272da42895fd42aa3ba6442ccee4844675..89add3afab68bb4439c780c0afc22a871d76d1e6 100644 --- a/README.md +++ b/README.md @@ -1,7 +1,5 @@ # Machine Week -## Intro - *Machines in a week* *It's easy, so to speak* *In minutia is mayhem* @@ -312,9 +310,6 @@ I ended up doing this a second time, with a better toolpath and a bigger bite.  - - - ### Doing the Milling  @@ -403,13 +398,13 @@ Now draw the rest of the owl ## Plugging in Motors -I made no concessions for wiring while I was designing - if you're going to 'rev' the machine I did, please do this! If not, do a bit of planning for your wiring. Just a bit. This part tends to be super-stochastic... My strategy is to drill holes where I want to mount wires, and loop zip-ties around them, in bundles, there. +I made no concessions for wiring while I was designing - if you're going to 'rev' the machine I made, please do this! If not, it pays to do a tiny bit of planning for your wiring. Keep in ind wires have to move. This part tends to be best detailed in-situ... My strategy is to drill holes where I want to mount wires, and loop zip-ties around them, in bundles, there. I got lucky and had accidentally spaced my bed-rails at the pitch of some mount holes on the Power Supply. Rad. I mounted those, and the TinyG. To bring power to the PSU, I cut up a DIN connector and plugged the GND, Line and Neutral lines in. -The TinyG gets power here - polarity should be obvious. Obviously, you should be being safe and not turning anything off yet! Careful with the TinyG polarity - it will die if you reverse these. +The TinyG gets power here - polarity should be obvious. You should be being safe and not turning anything <strike>off</strike> on yet! Careful with the TinyG polarity - it will die if you reverse these. Next, I drilled some holes in the chassis for my motor wires. I also found this rad 4-conductor cable in the basement at the CBA, I'll use that to route out to my motors. @@ -509,8 +504,7 @@ Now, you should be ready to move some motors about. # To Do - Link to Fusion 360 w/ cleaned Cam files - -to be linked - dan gelbart -talk about resolution vs. accuracy - repeatability vs absolute accuracty - global vs. local resolutions - -w/r/t True Level - Everything is crooked... lambs to the cosmic slaughter \ No newline at end of file +- Finish / Fix Loose Footnotes +- Link extra resources: Dan Gelbart, Slocum etc +- Chat aboot resolution vs. accuracy, global / local etc +- w/r/t *True Level* - Everything is crooked... lambs to the cosmic slaughter \ No newline at end of file